141
edits
Test Run: Difference between revisions
no edit summary
Yamato KOHNO (talk | contribs) No edit summary |
Yamato KOHNO (talk | contribs) No edit summary |
||
| Line 10: | Line 10: | ||
Main Window's menu bar: [Emit/SI]>[E-card] or Ctrl+E<br /> | Main Window's menu bar: [Emit/SI]>[E-card] or Ctrl+E<br /> | ||
The screen should say "Select a mode," so select "Test Run Mode." Next, select either "MTR" or "Reading Unit" depending on the equipment you are using, and the COM port number which the equipment is connected. Click [[here]] for instructions on how to check the COM port number. Also, click [[here]] for instructions on which equipment (MTR, reading units) to use and how to connect the equipment to the PC.<br /> | The screen should say "Select a mode," so select "Test Run Mode." Next, select either "MTR" or "Reading Unit" depending on the equipment you are using, and the COM port number which the equipment is connected. Click [[here]] for instructions on how to check the COM port number. Also, click [[here]] for instructions on which equipment (MTR, reading units) to use and how to connect the equipment to the PC.<br /> | ||
If you set the E-card the test runner used on the reading unit/MTR, the results will show on the screen. The course the runner ran will be automatically detected. You can also confirm the details by double-clicking the runner's name on the list below.<br /> | If you set the E-card which the test runner used on the reading unit/MTR, the results will show on the screen. The course the runner ran will be automatically detected. You can also confirm the details by double-clicking the runner's name on the list below.<br /> | ||
If the test runner did not punch the Finish control, the message "Finish unit/station is not checked" will be shown. If the course data recorded in Mulka2 is different from the data recorded in the E-card, the message "Wrong Punch," etc. will be shown. Please make sure to check which was wrong: either the course data or the test run. | If the test runner did not punch the Finish control, the message "Finish unit/station is not checked" will be shown. If the course data recorded in Mulka2 is different from the data recorded in the E-card, the message "Wrong Punch," etc. will be shown. Please make sure to check which was wrong: either the course data or the test run. | ||